BIZHUB 40P PCL DRIVER DOWNLOAD

Click on the arrow in front of any section to read the explanation. The following Order settings are Close the rear cover. Page Remove the moist media and replace it with new, dry media. Maintaining The Printer Maintaining the Printer

Uploader: Nikorr
Date Added: 11 January 2015
File Size: 64.73 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 55688
Price: Free* [*Free Regsitration Required]

bizhub 40P

Note The image is not fixed on the media before the fusing process. The printer data stream is not host-based. Control Panel Keys and Port Item Page Remove the transparencies and load them in the tray one sheet at a time.

Page Reattach the lid of the tray.

If necessary, contact Technical Support with the error information. If damaged, replace it. Symptom Cause Solution Lateral lines The printer is not Place the printer on a flat, hard, level or bands Solving Other Problems Solution Turn off the printer, gizhub that the power cord is correctly plugged into the outlet, and then turn on the printer.

Lift the lever at pcll top left hand side of the duplex to unlock it and open the duplex cover.

KONICA MINOLTA BIZHUB 40P USER MANUAL Pdf Download.

Close the offset tray cover. Insert the right and left tabs of the offset tray into the holes at the top of the printer and slowly put the offset tray down to the top of the printer. Load the correct media in the printer.

  ATI RADEON XPRESS 200M/1100M/1150M RS482M/RS485M DRIVER

However, when very little information is provided by the manufacturer it is often the case that the printer data stream is host-based. For Eu Member States Only You can install up to two optional lower feeder units Trays 3 and 4. Some popular printer data streams include:. Offset Printing If offset printing is selected, the paper is fed out shifted as shown below. Media that has been stored for a long time out of its packaging may dry up too much and cause misfeeding.

Align the front and back corners of the top and bottom feeder units, and slowly lower the top unit so that the guide pins at the 4 corners of the bottom unit fit into the holes of the base plate of the top unit. Remove the moist media and replace it with new, dry media.

Toner does not adhere well to moist or wet paper. UNIT Reset the service life counter for the fuser unit. Konica Konica with optional IP print controller. Loading the Paper Larger than A4 Open the tray and place it on a flat surface. Page Open the cover of the fuser unit and remove any misfed media.

  ELONEX WEBBOOK VIDEO DRIVER

For envelopes with the flap along the short edge, load the envelopes with the flap side down. Symptom Cause Solution You are Media or settings are For autoduplexing, make sure that you experienc- not correct.

This menu cannot be used by the user. When the Status Monitor detects a printing problem, the icon on the Windows task bar changes from green normal to yellow warningmagenta or red errordepending on the severity of the printer problem. Your bizhub 40P is specially designed for optimal performance in Windows, Macin- tosh and Linux environments.

Before replacing the fuser unit, wait about 30 minutes after turning off the machine, and then check that the fusing sec- tion has reached cpl temperature; Do not open the printer during printing. Risk of explosion if bat- tery is replaced by an incorrect type.

This printer weighs approximately 23 kg Adjust the humidity for media storage. Printing Preference dialog box appears.